GEVINO Motore - PLC - ARM Cortex M0+
Stepper Controller PLC Compatible Arduino Zero
On designing phase.
Available from September 2020
PLC for controlling Motors
A Stepper motor or Two DC motors
Constant current motore output 50V 5A (10A peak) per phase
Full step, Half step, Quarter step, 1/8 step, 1/16 step, 1/32 step, 1/64 step, 1/128 step.
On the Software, torque setting, frequency limits, selection of steps, Reading Current, ADMD setting: Advanced Dynamic Mixed Decay, Anti-stall,
5 digital inputs for PNP
4 Outputs PNP, protected against short circuit, 40V 2.5A, for resistive, inductive, capacitive, Loads.
3 analog inputs 20mA / 1V / 10V 12bit
1 RS485 port, which paralleling up to 255 gevini, or m-bus, or other.
On the front, behind the flap:
Led inputs, outputs, serial, power
Optional module Ethernet RJ45
Optional module WiFi ESP
48 Mhz, 32-bit ARM Cortex - M0+ processor.
Flash 256KB, RAM 32K
3 enclosures, of different thicknesses:
Thin 17.5mm black, for the only card without accessories.
Medium 22.5mm green,for accessories such as Ethernet, RTC, Wi-Fi, Bluetooth, GSM modem.
Thick 35mm black, for accessories such as RS232 on DB9 female, Li-Po battery with battery charger.